
An uneven pool deck isn't just cosmetic — it's a trip hazard around water. Get it raised back to level and properly draining, without draining the pool.
Pool deck sections closest to the water often settle first as soil around the pool shell shifts, creating an uneven line right where bare feet walk most.
A properly sloped deck sheds water away from the pool. A settled low spot collects it instead, which speeds up efflorescence, algae, and slip risk.
As one paver or slab section settles independently from its neighbors, cracks often form along the joint lines first.
If patio furniture visibly rocks or needs shims where it didn't before, the slab underneath has likely shifted.
An uneven deck edge combined with wet feet and bare skin is a genuinely higher-risk combination than the same unevenness on a dry walkway — pool decks deserve faster attention.
Water that should run away from the pool shell can instead pool against it when the deck settles, which over time can contribute to further shifting.
Uneven settling puts uneven stress on pool coping and tile lines, which can crack or pop loose faster than on a properly leveled, well-drained deck.
Small injection holes are drilled through the settled section of deck, spaced to cover the affected area evenly. A dense polyurethane foam is pumped beneath the slab through those holes; as it expands, it fills the eroded or compacted void and lifts the concrete back toward the level of the surrounding deck and coping.
Because the foam is inert, waterproof, and doesn't break down when it gets wet, it's well suited to the pool-adjacent environment — unlike traditional mudjacking slurry, which can be more vulnerable to erosion from splash-out and irrigation over time.
A contractor experienced with pool decks specifically will also check that the surrounding drainage slope is restored correctly, not just that the slab is flat — a level deck that still doesn't drain away from the pool will settle again faster.
Pool deck work happens close to expensive coping, tile, and plumbing — mistakes here are more costly to fix than on a plain walkway. Every contractor matched through Phoenix Concrete Lifting is vetted and insured before they're ever connected with a homeowner.
Other areas of the property also settling? See Sidewalk & Walkway Repair or Driveway Concrete Lifting.
In most cases, yes — polyurethane foam injection works from the deck surface and doesn't require draining the pool or disturbing the pool shell itself. A contractor can confirm this is true for your specific layout during the assessment.
Qualified contractors are experienced working around pool decks specifically and take the shell, plumbing, and coping into account when planning injection points. This is exactly the kind of job where choosing a vetted, insured contractor matters most.
Polyurethane foam typically cures within 15–30 minutes, and most decks are safe to walk on again within an hour or two — much faster than any replacement option.
Paver-based patios and pool decks can often be leveled too, either by injecting foam beneath the base or by lifting and resetting individual pavers, depending on the cause. A contractor can assess which approach fits your surface.
Tell us about your patio or pool deck and we'll connect you with a vetted, insured contractor near you — no cost, no obligation.